Hi
After creating Template file, .FIELDS file, I tried running EB.DEV.HELPER in verify mode. But, everytime it throws the folloiwng error.
Can any one tell me what this is, and how to get rid of it?

Thanks


Unable to perform CALL to subroutine HBL.PRAJ.SEQNO , Line 35 , Source EB.EXECUTE.
APPLICATION
Press C to continue or Q to quit
Trap from an error message, error message name = SUBROUTINE_CALL_FAIL
Line 35 , Source EB.EXECUTE.APPLICATION
jBASE debugger->

Hi,

Here there is problem in calling routine. Please very your routine name once again, in which the routines must be like(if your template routine is LOAN.APPLICATION): LOAN.APPLICATION & LOAN.APPLICATION.FIELDS and the EB.DEV.HELPER id must be LOAN.APPLICATION.

Regards,
Sumas

Thanks Sumalathas !

The problem was that I had not compiled my routines before running EB.DEV.HELPER. The problem is solved.

However, INSERT file did not get created. While runing EB.DEV.HELPER, it says that the INSERT file has been created.

What could have possibly gone wrong?

Hi,

Nothing has gone wrong.The insert file will be created in the BP folder which can be copied to your local BP using the copy command.

Cheers
Avinash

Thanks Avinash

Like you said, its was created in BP folder.

Hi Avinash,

I could not find the insert file in BP. Could you please tell me what could possible went wrong with me?

Thanks ina advance,

Hi,

Finally I found where I was doing mistake. I was puting any value in "Table.equatePrefix" parameter in template routine. After puting some valu there the insert file was created in BP.


thanks,