Setting up Printing -Windows Printing Environment

Hi everyone

I'm new to the site and rather new to T24.

I need assistance with setting up the Jbase printing part of our T24 environment.

This is what i've done so far :
1. On my AppServer, i've installed a Printer as local with the correct driver(postscript). Printer model is HP Laserjet 2605.
2. I've selected LPT1 as a port and created a TCP/IP Port pointing to the IP of the printer.
3. I've enabled Printer pooling.
4. I've shared the Printer as HPTEST
5. In Jbase, I ran this command as instructed :
SP-CREATE T24 PROG lp -d HPTEST (This completed without errors)
6. Then I ran SP-ASSIGN HPTEST (No errors)
7. Then we test by doing a jlp remote.cmd
8. Nothing happens at all.
9. Nothing in the queue, nothing!

Any advice?
Here my software environment
Server: Windows Server 2008
T24 version : R08
Jbase version : 5.0.16

What else can I try?
Thanks

Hi

Use the command jsp_scan -v and check if there is any error

rgds

if you go to SP-STATUS can you see the STANDARD printer? Is your print job queued in there?

SP-STATUS output would look like below. I tried without specifiying the printer jlp somefilename
then it goes to this printer.

UEUE NAME DEVICE STATUS #Q SKIP XLT BLKSZ

STANDARD 0 KILLED 97 1
TEST PROG lp -d prtutest ASSIGNED 0 1


Udayangi

I am not very much in to the windows environment but did you setup the jspooler directories?

hi Saahmad,

this is related to the topic, but im working in aix trying to setup the printer. so far this is what i have:

QUEUE NAME DEVICE STATUS #Q SKIP XLT BLKSZ

STANDARD PROG lp -d hppcl ASSIGNED 0 1

when i do a server print from t24, it is going to the Q and shortly after leaving it. however, it is not coming out from the printer. can you please help me with this.

thanks